FC + 100A STACK
A matched flight controller and 100A 4-in-1 ESC stack for high-power FPV builds. Every board is factory-tested and shipped as a complete assembly kit, so you can drop it straight into a 5-7 inch frame without sourcing extra hardware.
What's in the box:
- 1 x Flight controller board (USB-C, solder pads on all four sides)
- 1 x 100A 4-in-1 ESC board (per-motor solder pads M1-M4, direct battery input)
- 1 x Capacitor board with 2 x 2200uF / 35V low-ESR electrolytic capacitors
- 2 x XT60 power leads, 12AWG silicone wire (200C / 600V rated)
- 2 x JST-GH ribbon cables (FC to ESC signal)
- 1 set x M3 screws, M3 nylon nuts
- 8 x silicone anti-vibration grommets
Highlights:
- 100A continuous current rating, built for 6S-8S high-thrust freestyle and cinematic builds
- Onboard capacitor board suppresses voltage spikes and keeps the video feed clean
- Pre-assembled power harness with XT60 connectors, ready to solder to your PDB or battery lead
- Standard 30.5 x 30.5mm mounting pattern on both boards
Notes:
- Supplied as a stack kit; motors, props and receiver are not included.
- Please confirm firmware target (Betaflight / INAV) and motor protocol before flashing.
